Browse documentation

Docs / Manual rates and markup

On this page

Manual rates and markup

Pro’s Settings → AutoCurr → Rates lets publishers control conversion values used in displayed prices.

Manual exchange rates

Choose Add manual rate, select From currency and To currency, enter a positive rate, and save.

For example, EUR → USD at 1.20 means 1 EUR converts to 1.20 USD. The currencies must differ. Zero, negative or non-numeric rates are rejected.

An exact manual pair wins over provider rates. If only the reverse pair exists, AutoCurr uses its reciprocal: EUR → USD at 1.20 supplies USD → EUR at approximately 0.833333. An explicit USD → EUR rule wins over that reciprocal.

Manual pairs do not need a provider lookup. Other pairs use normal provider rates. Matching source and target always remain unchanged.

Exchange-rate markup

Exchange-rate markup defaults to 0 and accepts percentages from 0 to 100, including decimals. Enter 3 for 3%, without a percent sign.

The calculation is:

effective rate = underlying rate × (1 + markup / 100)
1.20 × 1.03 = 1.236

Markup applies to both manual and provider rates. A reciprocal is calculated before markup. Use 0 if your manual rate should apply exactly. Monetary rounding happens afterward according to display settings.

Changes and existing prices

These settings apply to normal prices, Library values and ranges. Changing them does not require clearing exchange-rate caches. Reload an already open page to fetch the new effective rate; normal page/CDN caching may also need clearing.